|
Adjustable forward and reverse time/speed delivers
a clean cut from the dispensing cycle.
The
5101497
Controller supplies material
pressure to the barrel feeding the
Auger Valve. It is adjusted
by a regulator and pressure gage.
The digital timer can be set
at intervals from 0.01 seconds –
99.99 hours.
When initiated, the controller
opens the air solenoid, allowing constant pressure to the fluid to keep
constant flow to the valve, while activating the motor.
To feed this IDS valve,
choose from our dispensing syringes, (to
feed thin to medium materials in very small shots) or smaller
single cartridges.
As the name suggests, a screw (or auger) drive is set in
motion, carrying the fluid with it to be deposited.
Both the air and the motor are on during
the time the signal is present. While the solenoid delivers the pneumatic
power to fill the threads of the auger with the fluid, the servo delivers
the power to turn the thread. When the thread turns clockwise, the fluid is
delivered forward; when reversed, the fluid is drawn back, giving complete
control over the dispensing process. When the signal is interrupted the unit
goes to rest. The flow and the rotation stop until the signal is once again
present.
IntelliSpense™ Auger Controller
Features
Specifications
-
Time range:
0.01 seconds –
99.99 hours
-
Resolution:
0.01 seconds
-
Timing accuracy:
0.03%
-
Output pressure:
5 – 60 PSI
(regulated)
-
Motor voltage:
24 vdc
-
Manual
operation:
Foot switch
(included)
-
Remote
operation:
External +24VDC
40ma
IntelliSpense™ Auger Controller Ordering
Information
7070000
Screw Valve Controller (for
lntelliSpense™ Auger Valves Only)
|
